Peel Away
Smart Strip - 2 Gallon Paint Removal System - Save Almost
$10
- Click
Here For MSDS Sheet
PRODUCT FEATURES:
- Removes up to 15 layers
of paint and industrial coatings in one application
- User friendly, does not
contain methylene chloride, caustic or toxic chemicals, will not burn hands
- Water based formula
- 100 % biodegradable
- Odor free
- Does not require neutralization
- For interior and exterior
use
Product Description:
A revolutionary paint remover that is safe for the user, the substrate and the
environment. This 100% biodegradable, water-based stripper is extremely effective
for removing multiple layers of architectural and industrial coatings from virtually
all interior/exterior surfaces - wood, brick, metal, concrete, stone, plaster,
fiberglass, etc. Smart Strip does not contain methylene chloride, caustic, or
toxic chemicals. It is odor free. Smart Strip is exceptional for the safe removal
of lead based paint and is excellent for intricate, carved or molded surfaces.
It is also great for removing marine paints without damaging the gel coat. Because
it is a paste, Smart Strip can easily be applied by brush, roller or conventional
airless sprayer. It is formulated to remain wet and effective over extended periods
of time and does not require the use of Peel Away Paper. Although the use of Peel
Away Paper will accelerate the removal process and extend dwell time. Peel Away
Paper can be purchased separately.
USE ON:
Works on almost all surfaces,
wood, brick, concrete, plaster, steel, iron, fiberglass, etc. Easily adheres
to vertical or overhang surface. Can be used on interior and exterior surfaces.
EASY TO APPLY:
Limitations: For best results, surface temperatures should be 60ºF – 95ºF. Product
can be applied as low as 37ºF, however, efficiency/effectiveness are reduced
and dwell time increases.
Test Patch: Always prepare
a test area on each type of surface and paint coating prior to full application.
Testing before beginning the project is the best way to ensure product suitability.
This will also determine the proper thickness of the remover and the dwell time
required for project completion.
Preparation: Mask/protect
areas where stripping is not desired, including adjoining surfaces where overspray
may travel. Polyethylene (plastic sheets) and masking tape create an effective
barrier. Plants and other foliage should be covered or rinsed thoroughly before
and during application.
NOTE: SMART STRIP™ will
not affect glass, aluminum, or plastic surfaces.
Application & Spread Rate:
Using brush, roller or airless spray, apply approximately 1/6” to 1/8” thick
(refer to test patch results) according to the age, number of layers, and type
of coating being removed. SMART STRIP™ provides an average spread rate of 45
- 50 sq. ft. per gallon; results may vary.
Removal: Remove softened/lifted
paint using a scraper, taping knife, squeegee or power washer. Agitate tough
to remove residue with a stiff nylon brush or scouring pad, paying particular
attention to crevices, grooves and cracks. Exterior stripped surfaces should
be rinsed thoroughly with a power washer. Interior surfaces can be rinsed using
a spray bottle or pail, a sponge and water, or denatured alcohol to remove remaining
residue.
Clean Up: Collect remover,
paste and paint residue in plastic bags and dispose of in compli-ance with local
government regulations. Do not collect or store removed paint/paste waste in
metal containers. Clean up airless sprayer by running water or denatured alcohol
through the equipment soon after application has been completed. Allow surface
to dry thoroughly before repainting.
Most Refinishers Require
extra Peel Away Paper. Purchase Peel
Away Paper Now with no additional postage.
Click Here
